How To Use

Short, practical setup notes for the gear we sell. If something here doesn't match what you've got in front of you, email us.

Lifting belt

Position the belt across your navel, not your hips. Take a breath into your stomach, brace against the belt, then fasten it — you want it tight enough that bracing meets resistance, loose enough that you can take that breath in the first place. Aim to close on a middle hole so you have room either way.

Wrist wraps

Anchor the thumb loop, wrap from just below the wrist joint upward, and finish with the velcro over the joint itself. Tighten for pressing and overhead work; loosen between sets so blood flow isn't cut off.

Knee sleeves

Roll them up from the ankle rather than pulling from the top, which stretches the cuff. The centre of the sleeve should sit over the kneecap. A properly sized sleeve is hard to get on — that's the point.

Lifting straps

Thread the strap through its loop, put your hand through, and wrap the tail around the bar in the direction your fingers curl. Roll the bar backward to tighten, then grip over the top of the strap.

Wrist roller

Start with a light plate — forearms fatigue faster than you expect. Hold your arms out at shoulder height, roll the weight all the way up, then lower it under control rather than letting it drop. That eccentric is where most of the work happens.

Doorway pull-up bar

Hook the bar over the frame and check that the backplate sits flat against the wall above the door. Put weight on it gradually before your first full hang, and re-check the seating every few sessions.

Ab roller

Start from your knees, on a mat. Roll out only as far as you can go without your lower back arching, then pull back with your abs rather than your hip flexors. Extend the range over weeks, not in one session.

Resistance bands

Inspect for nicks before each use and replace any band that's started to split. Anchor at a point that can't shift, and never let a stretched band go slack suddenly.